YOU CAN ALWAYS GO THROUGH THEIR MAIL - THEN BLACKMAIL!: "HEADCAVE"

Comments

Post a Comment

Popular posts from this blog

Drum Doctors

Cures For Common Drum Problems SNARE DRUMS Symptom: The Snare Drum has too much ring. Cures: 1. Tune the heads lower. 2. Use a heavier head (i.e. Coated CS with Dot on Bottom or Coated Emperor). 3. Use a full or partial muffling ring. 4. Use an alternate Snare Drum. 5. Have the edges checked and/or recut to a flatter angle. Symptom: The Snare Drum doesn’t have enough ring. Cures: 1. Tune the head higher. 2. Use a thinner head (i.e. Coated Ambassador or Diplomat). 3. Use an alternate Snare Drum. 4. Have the edges checked and/or recut to a sharper angle. Symptom: The Snares buzz when the Tom-toms are hit. Cures: 1. Check that the snares are straight. Replace as needed. 2. Check that the snares are flat and centered on the drum. 3. Loosen the bottom head. 4. Retune the offending toms. 5. Use an alternate Snare Drum. TOM-TOMS Symptom: One or more of the Tom-toms are difficult to tune, don’t blend or have an unwanted 'growl.' Cures: 1. Check the top hea...
Read more

How to load SoundFont Banks in both Synth A and Synth B in Cakewalk Sonar

Support - KnowledgeBase : "How to load SoundFont Banks in both Synth A and Synth B in Cakewalk Sonar The Sound Blaster Live!, Sound Blaster Audigy, Sound Blaster Audigy 2 and Sound Blaster Audigy 2 ZS cards have two hardware based MIDI Synth: Synth A and Synth B, each with 16 MIDI channels. To utilize all 32 MIDI channels, it is necessary to load SoundFont banks, either same or different SoundFont files for both of them. To load SoundFont Banks with a Sound Blaster Live, Sound Blaster Live! 5.1, or Sound Blaster Audigy card, go to AudioHQ in Control Panel, then click on SoundFont. Click on the Options tab, and select SB Audigy Synth A (or similar), then click the Configure Bank tab and load each of the desired SoundFont files. Repeat the procedure for SB Audigy Synth B (or similar). To load SoundFont Banks with a Sound Blaster audigy 2 card, go to Start, Programs, Creative, Sound Blaster Audigy 2, then click on SoundFont Bank Manager. Click on MIDI Device, select Synth A...
Read more